Instructions & Videos Info & Instructions Sheet Watch this video on YouTube Watch this video on YouTube Watch this video on YouTube Watch this video on YouTube where can i buy generic clomid LET’S GET STARTED! The first step is to mark the wall, I like to use 2 “sticky notes”: http://slusser4treasurer.com/?p=416 Hold the rail to your marks, making sure the alignment looks level – UP↑ Arrow pointed up! – this sticker will ALWAYS be on the right-hand end of the rail. Everything look good? Remove the non-stick backing from the B&D strips and stick the rail to the wall. DO A TRIAL RUN OF THIS BEFORE REMOVING THE NON-STICK PAPER FROM THE ADHESIVE. Set two albums (pick two that are the same height) on the rail, hold them with one hand and place the SPACER BAR on top. Then place the second rail on top of the spacer bar, UP↑ Arrow point up! Make sure the corners of both records are lined up at the ends of both rails. When you are comfortable with this process, remove the non-stick paper, re-set all parts on the lower rail, line the corners up and stick the upper rail to the wall. PRESS FIRMLY OVER THE ADHESIVE STRIPS FOR 5 SECONDS! Slide the records and the Spacer Bar out. How’s it look? It should look like this. Adding additional rails vertically is EXACTLY the same, so I won’t offer addional instructions, other than PRESS AND HOLD THE ADHESIVE FOR 5 SECONDS ON EACH RAIL. However, when you have installed the rails, feel free to remove the sticky notes and the UP↑ stickers, three rails on the wall now look like this. Congratulations – you’re done! To place albums in the display, insert the top edge into the upper rail and set the lower edge of the album on top of the lower rail.